Driving/operation is done using servo-drives or stepper-drives by means of the linear actuator integrated bolt screw. Full control of the actuator position throughout the length of its track is achieved, thus covering all the applications that cannot be done using the traditional actuators or air actuators.


  • Stroke lengths up to 2400mm
  • Ball screw pitches from 5 to 50 mm/rev.
  • Thrust forces in excess of 44,000N
  • Typical repeatability ± 0.013mm
  • Speeds up to 1 m/s
  • Timing belt pulley drive (with parallel motor (Installation), available with 4 drive ratios
  • High mechanical efficiency (up to 90%)
  • IP65 version available
  • Totally compatible dimensions with the “traditional” actuators.
  • 5 different frame sizes